Virtual Private Routed Network Services
7210 SAS-X OS Services Guide Page 747
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used to identify and reference a given service once it is initially created.
Parameters service-name — Specifies a unique service name to identify the service. Service names may not begin
with an integer (0-9).
snmp-community
Syntax snmp-community community-name [version SNMP-version]
no snmp-community [community-name]
Context config>service>vprn
Description This command sets the SNMP community name to be used with the associated VPRN instance.
If an SNMP community name is not specified, then SNMP access is not allowed.
The no form of the command removes the SNMP community name from the given VPRN context.
Default None — The SNMP community must be explicitly specified.
Parameters community-name — Specifies one or more SNMP community names.
version SNMP-version — Specifies the SNMP version.
Values v1, v2c, both
source-address
Syntax source-address
Context config>service>vprn
Description This command enables the context to specify the source address and application that should be used
in all unsolicited packets.
application
Syntax application app [ip-int-name|ip-address]
no application app
Context config>service>vprn>source-address
Description This command specifies the source address and application.
Parameters app — Specify the application name.
Values telnet, ssh, traceroute, ping
ip-int-name | ip-address — Specifies the name of the IP interface or IP address. If the string contains
special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
To Next Page
Loading...
