EasyManua.ls Logo

Alcatel-Lucent 7210 SAS-X - Page 815

Alcatel-Lucent 7210 SAS-X
948 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Virtual Private Routed Network Services
7210 SAS-X OS Services Guide Page 815
med-out
Syntax med-out {number | igp-cost}
no med-out
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command enables advertising the Multi-Exit Discriminator (MED) and assigns the value used
for the path attribute for the MED advertised to BGP peers if the MED is not already set.
The specified value can be overridden by any value set via a route policy.
This configuration parameter can be set at three levels: global level (applies to all peers), group level
(applies to all peers in peer-group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command used at the global level reverts to default where the MED is not
advertised.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default no med-out
Parameters number — The MED path attribute value, expressed as a decimal integer.
Values 0 — 4294967295
igp-cost — The MED is set to the IGP cost of the given IP prefix.
min-as-origination
Syntax min-as-origination seconds
no min-as-origination
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command configures the minimum interval, in seconds, at which a path attribute, originated by
the local router, can be advertised to a peer.
This configuration parameter can be set at three levels: global level (applies to all peers), group level
(applies to all peers in peer-group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command used at the global level reverts to default.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default 15 seconds

Table of Contents