Alcatel-Lucent 7210 SAS-X - Page 860

Show, Clear, Debug Commands
Page 860 7210 SAS-X OS Services Guide
Service Id
The service identifier.
Port Id
The ID of the access port where this SAP is defined.
Description
Generic information about the SAP.
Admin State
The desired state of the SAP.
Oper State
The operating state of the SAP.
Last Changed
The date and time of the last change.
Admin MTU
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Ingress qos-pol-
icy
The SAP ingress QoS policy ID.
Egress qos-policy
The SAP egress QoS policy ID. This command is applicable only to
7210 SAS X.
Acct. Pol
Indicates the accounting policy applied to the SAP.
Collect Stats
Specifies whether accounting statistics are collected on the SAP.
Spoke SDPs
Managed by Service
Specifies the service-id of the management VPLS managing this spoke
SDP.
Managed by Spoke
Specifies the sap-id inside the management VPLS managing this spoke
SDP.
Prune state
Specifies the STP state inherited from the management VPLS.
Peer Pw Bits
Indicates the bits set by the LDP peer when there is a fault on its side of
the pseudowire. LAC failures occur on the SAP that has been config-
ured on the pipe service, PSN bits are set by SDP-binding failures on
the pipe service. The pwNotForwarding bit is set when none of the
above failures apply, such as an MTU mismatch failure. This value is
only applicable if the peer is using the pseudowire status signalling
method to indicate faults.
pwNotForwarding — Pseudowire not forwarding
lacIngressFault Local — Attachment circuit RX fault
lacEgresssFault Local — Attachment circuit TX fault
psnIngressFault Local — PSN-facing PW RX fault
psnEgressFault Local — PSN-facing PW TX fault
pwFwdingStandby — Pseudowire in standby mode
Label Description