Show, Clear, Debug Commands
Page 868 7210 SAS-X OS Services Guide
Sample Output
*A:ALA-12# show service id 321 interface
===============================================================================
Interface Table
===============================================================================
Interface-Name Type IP-Address Adm Opr Type
-------------------------------------------------------------------------------
test Pri 190.11.1.1/24 Up Up IES
-------------------------------------------------------------------------------
Interfaces : 1
Label Description
Interface-Name
The name used to refer to the interface.
Type
Specifies the interface type.
IP-Address
Specifies the IP address/IP subnet/broadcast address of the interface.
Adm
The desired state of the interface.
Opr
The operating state of the interface.
Interface
If Name
The name used to refer to the interface.
Admin State
The desired state of the interface.
Oper State
The operating state of the interface.
IP Addr/mask
Specifies the IP address/IP subnet/broadcast address of the interface.
Details
If Index
The index corresponding to this interface. The primary index is 1. For
example, all interfaces are defined in the Base virtual router context.
If Type
Specifies the interface type.
Port Id
Specifies the SAP’s port ID.
SNTP B.Cast
Specifies whether SNTP broadcast client mode is enabled or disabled.
Arp Timeout
Specifies the timeout for an ARP entry learned on the
interface.
MAC Address
Specifies the 48-bit IEEE 802.3 MAC address.
ICMP Mask Reply
Specifies whether ICMP mask reply is enabled or disabled.
ICMP Details
Redirects
Specifies the rate for ICMP redirect messages.
Unreachables
Specifies the rate for ICMP unreachable messages.
TTL Expired
Specifies the rate for ICMP TTL messages.
To Next Page