Alcatel-Lucent 7210 SAS-X - Page 906

Show, Clear, Debug Commands
Page 906 7210 SAS-X OS Services Guide
Interface
-------------------------------------------------------------------------------
If Name : i1
Admin State : Up Oper (v4/v6) : Down/--
Protocols : None
IP Addr/mask : Not Assigned
-------------------------------------------------------------------------------
Details
-------------------------------------------------------------------------------
Description : (Not Specified)
If Index : 2 Virt. If Index : 2
Last Oper Chg: 03/07/2001 01:47:29 Global If Index : 127
Port Id : 1/1/1
TOS Marking : Trusted If Type : Network
Egress Filter: none Ingress Filter : none
Egr IPv6 Flt : none Ingr IPv6 Flt : none
SNTP B.Cast : False QoS Policy : 2
Queue-group : None
MAC Address : 00:25:ba:0d:27:32 Arp Timeout : 14400
IP Oper MTU : 9198
LdpSyncTimer : None Strip-Label : Disabled
uRPF Chk : disabled
uRPF Fail By*: 0 uRPF Chk Fail Pk*: 0
ICMP Details
Redirects : Number - 100 Time (seconds) - 10
Unreachables : Number - 100 Time (seconds) - 10
TTL Expired : Number - 100 Time (seconds) - 10
===============================================================================
Meter Statistics
===============================================================================
-------------------------------------------------------------------------------
Packets Octets
-------------------------------------------------------------------------------
Ingress Meter 1 (Unicast)
For. InProf : 0 0
For. OutProf : 0 0
Ingress Meter 9 (Multipoint)
For. InProf : 0 0
For. OutProf : 0 0
===============================================================================
===============================================================================
* indicates that the corresponding row element may have been truncated.
*A:7210SAS>show>router#
Detailed IP Interface Output — The following table describes the detailed output fields for an IP
interface.
Label Description
If Name
The IP interface name.
Admin State
Down — The IP interface is administratively disabled.
Up — The IP interface is administratively enabled.