Alinco DR-735T/E - Page 17

15
Controls, Connectors, and Display
 Functions that requires press and holding to be activated
No. Key Function
B
Left band [VOL] knob Switches between VHF/Air-Band and UHF on the left band (P.19)
C
Right band [VOL] Knob Switches between UHF/VHF and Air-Band on the right band (P.19)
H
Left band dial Switches between VFO and memory scan on the left band. (P.58)
I
Right band dial Switches between VFO and memory scan on the right band. (P.58)
J
[FUNC] key Sets mode. (P.34)
K
Left-Band [V/M] key Switches to Call channel on the Left-Band. (P.30)
L
Right-Band [V/M] key Switches to Call channel on the Right-Band. (P.30)
M
[MW] key Simple Memory writing. (P.24)
O
[H/L] key Key lock. (P.62)
* Hold timing is adjustable in set mode
 Functions which can be activated while [FUNC] appears, after pressing [FUNC] key
No. Key Function
B
Left band [VOL] knob Switches to the single band mode on the left band. (P.57)
C
Right band [VOL] knob Switches to the single band mode on the right band. (P.57)
H
Left band dial Program scan on the left band. (P.59)
I
Right band dial Program scan on the right band. (P.59)
K
Left band [V/M] key Write frequency to selected memory on the left band. (P.23)
L
Right-Band [V/M] key Write frequency to selected memory on the right band. (P.23)
M
[MW] key Sets monitor function. (Reverse function when shift activated). (P.31)
N
 key
Selects Tone-squelch (CTCSS) or DCS. (P.65)
O
[H/L] key Accesses the digital voice communication mode (required optional unit) (P.68)
 Functions which can be activated while pressing the [FUNC] key
No. Key Function
A
Power key
Normal Reset when turns the power on. (P.75)
B
Left band [VOL] knob Selects shift or offset frequency on the left band. (P.22)
C
Right band [VOL] knob Selects shift or offset frequency on the right band. (P.22)
H
Left band dial Sets priority scan on the left band. (P.61)
I
Right band dial Sets priority scan on the right band. (P.61)
K
Left band [V/M] key Erase the memory while memory mode is selected on the left band. (P.25)
L
Right band [V/M] key Erase the memory while memory mode is selected on the right band. (P.25)
M
[MW] key Sets auto-dialer memory. (P.67)
N
 key
Sets RGB backlight color. (P.63)
O
[H/L] key Sets the channel name while Memory mode selected. (P.28)