Alinco DR-735T/E - Set mode menu; Attenuator and Memory Protection

44
Set mode menu
Menu16.Attenuatorsetting
Attenuator reduces sensitivity intentionally. When a very strong signal
is being received in near-by frequency, it may interfere the signal you
are receiving. By reducing the sensitivity, such interference may be gone.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 16.
2. Rotate either left or right dial to set the
parameter. Available parameters are
shown below.
This function is assignable to left and
right VFOs separately, but not to each
band.
3. Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.
• OFF : Attenuator function is disabled.
• SQ : The attenuator functions in relation with the squelch level. Rotate the dial clockwise
until ATT is displayed and to obtain an appropriate level. The maximum level is about
10dB.
The squelch level remains at a center-position of the squelch knob while ATT is
activated.
• ON : 10dB attenuation is activated always. When attenuator is ON, ATT appears on the
display.
Menu17.Memoryprotection
This is to prevent important data from being deleted or overwritten accidentally.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 17.
Factory default setting is [OFF].
2. Rotate the right dial to select ON or OFF.
OFF allows overwriting and editing the
memory channels, ON to prohibit. This
setting becomes effective regardless of
bands and VFOs.
3. Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.