Alinco DR-735T/E - Set mode menu; VFO Beep and Pager (Bell) Features

39
Set mode menu
Menu07.VFObeepON/OFF
A beep sounds at 500KHz/1MHz order while scanning or selecting the frequency. Such beep
can be muted.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 07.
Factory default setting is [ON].
2. Rotate the right dial to select a desired
parameter. This setting affects regardless
of the band or VFO.
3. Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.
Menu08.PagerON/OFF(BELLfeature)
A pager (BELL) informs you that you are being called by sounding a bell, and flashing the
bell icon on the display.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 08.
Factory default setting is [OFF].
This parameter can be selected for both
left and right VFO but cannot be selected
for each band.
2. Rotate the dial of desired side to select
ON to activate, OFF to deactivate.
3. Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.
When BELL is on:
• Bell icon appears on the display.
• When squelch becomes open, bell icon will flash and a beep sounds.
• No beep will sound during communications.
• After 10 seconds since receiving signal is gone, BELL feature resumes. The bell icon stays
flashing until any key may be operated.