Alinco DR-735T/E - Specification; General Specifications

78
Specication
General
Frequency coverage
DR-735T
VHF
108.000 ~ 135.995MHz (RX)
136.000 ~ 173.995MHz (RX)
144.000 ~ 147.995MHz (TX)
UHF
400.000 ~ 479.995MHz (RX)
430.000 ~ 449.995MHz (TX)
Frequency coverage
DR-735E
VHF
108.000 ~ 135.995MHz (RX)
136.000 ~ 173.995MHz (RX)
144.000 ~ 145.995MHz (TX)
UHF
400.000 ~ 479.995MHz (RX)
430.000 ~ 439.995MHz (TX)
Operating mode
16K0F3E (Normal mode)
8K50F3E (Narrow mode)
Frequency resolution 5, 6.25, 8.33, 10, 12.5, 15, 20, 25, 30, 50, 100KHz
Number of memory channels 1000ch+100ch(dual)
Antenna impedance 50Ω unbalanced
Power requirement 13.8V DC ±15% (11.7 to 15.8V)
Ground method Negative ground
Current drain
Receive 0.6A (Max.) 0.4A (Squelched)
Transmit 12.0A
Operating temperature -10°C to 60°C
Frequency stability ±2.5ppm
Dimensions 140 (w)×Front: 60 Body: 40 (h)×188(d) mm
Weight Approx. 1.3kg
Transmitter
Output power High: 50W Mid : 20W Low : 5W
Modulation system Variable reactance frequency modulation
Maximum frequency deviation ±5kHz (Wide mode) ±2.5kHz (Narrow mode)
Spurious emission -60dB
Adjacent channel power -60dB
Noise and hum ratio -40dB (Wide mode) -34dB (Narrow mode)
Microphone impedance 2kΩ
Receiver
Sensitivity -16dBu for 12dB SINAD
Receiver circuitry Double conversion super heterodyne
Intermediate
frequency
VHF MAIN
UHF SUB
1st 21.7MHz 2nd 450kHz
UHF MAIN
VHF SUB
1st 30.85MHz 2nd 455kHz
Squelch sensitivity -18dBu
Selectivity (-6dB/-60dB) 12kHz/24kHz
Inter modulation rejection ratio 60dB
Spurious and image rejection ratio 70dB
Audio output power >2.0W (8Ω,10%THD)
All specifications are subject to change without notice or obligation.