Alinco DR-735T/E - Easy Memory Programming Mode; Programmable Data in the Memory Channel; Recalling a Memory Channel

24
Basic Operations
4. By pressing V/M key while [FUNC] icon is
on the display, programming will be
completed and you will hear a beep
sound.
IMPORTANT
Be certain memory protect function in set mode is off to edit the memory
channels.
Easymemoryprogrammingmode
One-touch programming is possible if you don’t care selecting specific memory channel
Number.
Select a frequency to be programmed in the VFO mode and set the parameters as
appropriate. Refer to the below for programmable parameters.
Press and hold MW key until a beep sounds, the current setting will be stored in an empty
memory channel of the lowest number and the number flashes 2 times.
Programmabledatainthememorychannel
Each memory channel including 000 to 999, d00 to d99, L00 to L99, CALL channel, APL/
APH and PA/Pb channels can store following:
• Frequency
• Output power
• Color setting
• Shift frequency
• Shift direction (+ / -)
• Tone encoder frequency
• Tone decoder frequency
• Tone encoder / decoder setting
• DCS code
• DCS setting
• Narrow mode setting
• AM mode setting
• Bell setting
Recallingamemorychannel
1. Select the memory mode by pressing V/M
key.
Repeat to switch between memory and VFO mode.
2. Select a memory channel.
Rotating dial (or pressing UP/DOWN keys on
microphone) will increase or decrease a memory
channel number by 1 channel step.
memory channel