Alinco DX-SR8 - Mode Selection (SSB, AM, FM, CW); Amateur Radio Band Selection

24
Chapter 1 Getting Started
Quick Reference of Control keys
There are 3 types of key operations; simply press it, press it after [FUNC] key, or press
and hold it for more than 1 second (*).
NOTE: FUNC + this key: Press [FUNC] key, then press this key.
(P.xx) refers to the page this operation is mentioned in this manual.
This key only FUNC + this key (See NOTE)
FUNC Accesses the FUNC mode.
* Accesses Parameter setting mode. (P.70)
–
V/M
Switches between VFO Mode and Memory Mode.
* Activates VFO A = B function (P.66)
Switches to memory bank.
* Program memory channels.
M/KHz Changes cursor position for setting band/
memory/frequency with [UP/DOWN] keys.
(P.27)
Switches between AGC-S and AGC-F.
MODE Selects the USB, LSB, CWU, CWL, AM,
FM modes.
* The mode UP/DOWN operation is
available. (P.26)
Switches between UT and LT. (P.46)
RF Changes RF gain.
* Monitors transmit frequency. (P.45)
Switches between narrow fi lter ON/OFF.
(P.64)
LOCK Locks main dial tuning. (P.68) Locks keys and main dial tuning. (P.68)
MULTI Accesses the Multifunction. (P.67) The allotment setting of the [MULTI] key.
Ÿ UP of MHz, kHz, BAND and Memory.
* Changes automatically while the key is
pressed.
–
ź DOWN of MHz, kHz, BAND and Memory.
* Changes automatically while the key is
pressed.
–
RIT
Switches TXIT/RIT function ON/OFF. (P.65) ±'f function of TXIT/RIT. (P.66)
1 To recall the 1.8 MHz BAND.
Frequency direct input “1”.
Switches between VFO A and VFO B.
Switches between memories bank A, B and blank.
2 To recall the 3.5 MHz BAND.
Frequency direct input “2”.
Transfers memory to VFO. (P.53)
3
To recall the 5.3 MHz BAND.
Frequency direct input “3”.
Erases memory channel. (P.52)
4 To recall the 7 MHz BAND.
Frequency direct input “4”.
Switches CTCSS tone ON/OFF. (P.42)
(FM Mode only)
5 To recall the 10 MHz BAND.
Frequency direct input “5”.
SPLIT function ON/OFF. (P.45)
6 To recall the 14 MHz BAND.
Frequency direct input “6”.
PRIORITY function ON/OFF. (P.61)
7 To recall the 18 MHz BAND.
Frequency direct input “7”.
QUICK OFFSET function. (P.42)
8 To recall the 21 MHz BAND.
Frequency direct input “8”.
The scan starts. (P.57)
9 To recall the 24 MHz BAND.
Frequency direct input “9”.
NB (noise blanker) ON/OFF. (P.64)
0 To recall the 28 MHz BAND.
Frequency direct input “0”.
Changes RF output power. (P.34)
. Enters a frequency direct input 100 kHz.
Frequency direct input decimal
Starts tuning an external automatic antenna
tuner. (Option)
ENT Enters a frequency direct input. Channel name (Alphanumeric) registration
function. (Only in Memory Mode) (P.53)