Publication 1756-UM523F-EN-P - December 2006
62 Configure the System Redundancy Module
Change Program Control
You can direct the controller to send a message to the 1757-SRM
module or block the controller from doing so.
Perform this procedure when you:
• initially configure the SRM.
• decide to send the SRM a message from the controller.
Before You Begin
See page 91 for a list of messages that a controller can send to an SRM
module.
3. Set the auto-synchronization option. A. Click Configuration.
B. Select the Auto-Synchronization option.
C. Choose Apply and then Yes to continue.
D. Choose OK.
Action Details
To Next Page
Loading...
