Amazone DMC 6000-2C - Placing the Machine in the Working Position

Use of the machine
122
Primera BAG0175.3
07.18
Filling with filling auger:
Before switching off the filling auger must run completely empty.
A start with a full auger could cause the whole system to fail.
10.2 Placing the machine in the working position
Change the machine from the transport position
to the working position:
Fig.
105
1. Move the stop tap (1, 2) to position A
→ The exact harrow is unlocked..
2. Activate yellow tractor control unit.
Gleichzeitig Traktorsteuergerät blau betäti-
gen.
→ The booms and exact harrow are folded
out.
3. Remove the road safety bars (Fig. 114/3).
4. Move the stop tap to position B.
5. Briefly activate yellow tractor control unit to
relieve the drive wheel clamp.
6. Unlock the drive wheel from the transport
position, see Fehler! Textmarke nicht
definiert..
7. Actuate yellow tractor control unit.
→ Lower the coulters, exact harrow and drive
wheel.
8. Actuate green tractor control unit.
→ Fold out the desired track marker.
Fig.
106
Fig.
107