General Safety Instructions
BAG0175.3 07.18
• After removing the PTO shaft, attach the protective sleeve to the
universal joint shaft stub.
• When using the travel-dependent universal joint shaft, note that
the universal joint shaft speed depends on the drive speed, and
that the direction of rotation reverses when you drive in reverse.
2.16.5 Attached machines
• Comply with the approved combination options for the attach-
ment equipment on the tractor and the machine drawbar.
Only couple approved combinations of vehicles (tractor and at-
tached machine).
• In the case of single axle machines, observe the maximum per-
mitted drawbar load of the tractor on the attachment equipment.
• Ensure that the tractor has sufficient steering and braking power.
Machines connected to a tractor can influence your driving be-
haviour, as well as the steering and braking power of the tractor,
in particular in the case of single axle machines with the drawbar
load on the tractor.
• Only a specialist workshop may adjust the height of the drawbar
on yoke bars with a drawbar load.
To Next Page
Loading...
