Amazone DMC 6000-2C - Lubrication Specifications (Workshop Work); Lubrication Point Overview

Cleaning, maintenance and repairs
Primera
BAG0175.3 07.18
133
12.2 Lubrication specifications (workshop work)
Lubricate all grease nipples (keep gaskets clean).
Lubricate / grease the machine at the specified
intervals.
Lubrication points on the machine are indicated
with the foil sticker (Fig. 128).
Carefully clean the lubrication points and grease
gun before lubrication so that no dirt is pressed
into the bearings. Press the dirty grease out of
the bearings completely and replace it with new
grease.
Fig.
114
Lubricants
For lubrication, use a lithium saponified, multipurpose grease with EP
additives:
Company
Lubricant designation
Normal use conditions
Extreme use conditions
ARAL
Aralub HL 2
Aralub HLP 2
FINA
Marson L2
Marson EPL-2
ESSO
Beacon 2
Beacon EP 2
SHELL
Retinax A
Tetinax AM
12.2.1 Lubrication point overview
Fig.
125
Lubrication point
Interval
Quantity
1x
in the season
every 100 h
(1)
Hydraulic cylinder for folding the sections
X
8
(2) Drawbar
X
4
(3) Markers
X
4
(4) Coulter
X X
5 / Coulter
(5) Hydraulic cylinder for harrow sections 6
(6) Brake shaft bearing
X
2
(7)
Renew wheel hub bearing grease, check
taper roller bearings for wear
X
2