Cleaning, maintenance and repairs
Primera BAG0175.3
• Regular and proper maintenance will keep your machine in good
condition for a long time, and will prevent premature wear. Regu-
lar and proper maintenance is a requirement of our warranty
conditions.
• Use only genuine AMAZONE spare parts (see "Spare and wear
parts and aids" section, page 15).
• Use only genuine AMAZONE replacement hoses, and hose
clamps made of V2A for assembly.
• Specialist knowledge is required for carrying out testing and
maintenance operations. This specialist knowledge is not im-
parted here in this operating manual.
• Observe environmental protection measures when carrying out
cleaning and maintenance work.
• Observe legal requirements when disposing of lubricants, e.g.
oils and grease. Parts that come into contact with these lubri-
cants are also affected by these legal requirements.
• Do not exceed a greasing pressure of 400 bar when greasing
with high pressure grease guns.
• The following are absolutely prohibited:
ο drilling the chassis.
ο enlarging pre-existing drilled holes on the transport frame.
ο welding on load-bearing components.
• Protective measures are necessary, such as covering or remov-
ing lines in particularly critical locations
ο during welding, drilling and grinding work.
ο when working with cut-off wheels near plastic wires and
electric wires.
• Disconnect the machine cable and power supply from the on-
board computer when carrying out any cleaning or maintenance
work. This applies especially to welding work on the machine.
To Next Page
Loading...
