Amazone UF 01 - Setting the Hydraulic Throttle Valves

Assembly and function
UF 01 DB 238. 07.04
129
4.10.3.9 Setting the hydraulic throttle valves
Factory set are the actuation speeds of the individual hydraulic
functions on the relevant hydraulic throttle valves from valve
block (Fig. 144 to Fig. 147) (fold up and down folded boom pack-
ages, fold in and out sprayer booms, lock and unlock swing compen-
sation etc.). However, depending on the tractor, it may be necessary
to adjust this setting.
By screwing in or out the Allen key headed set screw on each throttle
valve the speed for actuating the hydraulic function allocated to the
relevant pair of throttle valves can be altered.
• Reducing the actuating speed = screw in the Allen key headed
set screw.
• Increasing the actuating speed = screw out the Allen key headed
set screw.
Important!
For correcting the actuating speed always alter both throttle
valves of the relevant hydraulic function equally.
Profi-folding "0"
Fig. 144/...
(1) Throttle valve - locking the swing compen-
sation.
(2) Hydraulic connection - height adjustment
(the throttle valve is located on the left hand
hydraulic ram of the height adjustment).
(3) Hydraulic connections - tilt adjustment (the
throttle valves are located on the hydraulic
ram of the tilt adjustment).
(4) Throttle valve - folding out right and left
hand boom.
(5) Throttle valve - folding in right and left hand
boom.
Fig. 144
1
2
4
5
3