Assembly and function
UF 01 DB 238. 07.04
73
4.9.7.5 Storage of impulses per 100m for different tractors
1. Recall via the functional field the en-
tering "Please select tractor.
2. Select the desired tractor. For this see
"Selection of options", page 59.
3. Recall via the functional field
the input
"Please enter tractor name". If necessary
change the tractor name. Please refer to
chapter "Entering of text and figures", page
59.
4. Recall the functional field
.
5. Recall via the functional field
the in-
put "Please enter impulses per 100m for
this tractor" .
6. Manually enter the calibration value "Im-
pulses per 100m". Please refer to chapter
"Entering of text and figures", page 59.
7. Recall the functional field
.
Fig. 63
4.9.7.6 Permanently switch on / off the boom part width sections
1. Select the desired boom part width section
which you intend to switch on or off.
see "Selection of options", page 59.
2. Press key
.
→ Opposite the selected part section the word
"on" appears (boom section switched on) or
"off" (boom section switched off).
3. Repeat the steps 1 and 2, if you intend to
switch on/off additional boom sections.
4. Actuate the functional field
.
→ The boom sections identified with "off" are
permanently switched off during the spray-
ing operation.
Fig. 64
Hint!
If you intend to operate with this
boom section again, you have to
switch on the
off boom section again!
To Next Page
Loading...
