Assembly and function
UF 01 DB 238. 07.04
49
4.6 Induction bowl with injector and canister flushing
Fig. 22/...
(1) Swivelable induction bowl for pouring in,
diluting and sucking of crop protection
agents and Urea.
(2) Folding lid with spray rate chart (for using
the spray rate chart please refer to chapter
"Spray rate chart", page 219.
(3) Folding lid locking.
(4) Joint axle for swivelling the induction bowl
from the transport into the operational posi-
tion. The induction bowl catches in the rele-
vant locking positions.
(6) Reversing tap suck off induction bowl / Fill-
ing port.
(7) Filling port induction bowl.
(8) Suction hose of the induction bowl.
Fig. 22
Fig. 23/...
(1) Reversing tap Circuit line / Canister flush-
ing.
(2) Bottom sieve.
(3) Rotating canister flushing nozzle for rinsing
canisters or other containers.
(4) Pressure plate.
(5) Circular pipe line for diluting and inducting
crop protection agents and urea.
(6) Folding lid.
Hint!
Water escapes from the canister
flushing nozzle (Fig. 23/3) when
x the pressure plate (Fig. 23/4) is
pressed downwards by the
canister.
x the closed folding lid (Fig. 23
presses the canister flushing
nozzle downwards.
Fig. 23
Warning!
Close the folding lid (Fig. 23/6), be-
fore rinsing the induction bowl.
1
2
3
4
6
7
8
1
2
3
4
5
6
To Next Page