Putting into operation
192
UF 01 DB 238. 07.04
6.8.1 Enter the order related data into the
Important!
Before starting the spraying operation enter the order related
data into the
. Please refer to chapter "Menu
order", page 61.
6.8.2 Spraying crop protection liquid
Important!
x Couple the field sprayer to the tractor as prescribed!
x Connect the cable of the implement computer with the
.
x Before starting the spraying operation check the following
implement data in the
(please refer to
chapter "Menu implement data", page 62):
x percentage application rate increase.
x the values for the permissible sign spray pressure-
range of the nozzles fitted to the sprayer boom.
x the value "Impulses per 100m".
x Enter the order related data in the correct manner "into"
.
x Take the relevant measures if during the spraying operation
a fault message appears on the display of the
and at the same time an audible alarm
signal sounds. Please refer to chapter "Fault messages and
audible alarm signals", page 195.
x Check the indicated spray pressure during the spraying
operation.
Ensure that the indicated spray pressure by no means devi-
ates more than r25% from the intended spray pressure
taken from the spray rate chart, e.g. when changing the
spray rate via the plus/minus keys. Bigger deviations from
the intended spray pressure do not allow any optimum suc-
cess of your plant protective measures and will cause envi-
ronmental pollution.
Important!
Reduce or increase the forward speed until you return to the
permissible spray pressure range for the intended spray
pressure.
x Never empty the spray cocktail tank entirely (this is not ap-
plicable when finishing the spraying operation). Refill the
spray cocktail tank at a filling level of approx. 50 litres at the
latest.
x After having finis
hed the spraying operation, at a filling level
of approx. 50 litres,
x the reversing tap Spraying operation / Flushing in posi-
tion "Flushing".
x switch off the agitation.
To Next Page