Putting into operation
152
UF 01 DB 238. 07.04
6.1.1.7 Table
Actual value according to
the calculation
Permissible value
according to the trac-
tor-instruction manual
Double the permis-
sible tyre carrying
capacity (two tyres)
Minimum ballast
Front / rear
/
kg -- --
Total weight kg
≤
kg --
Front axle load kg
≤
kg
≤
kg
Rear axle load kg
≤
kg
≤
kg
Hint!
Please take the permissible values for the tractor total weight,
axle loads and tyre carrying capacity from the registration pa-
pers of your tractor.
Danger!
The actual calculated values must be smaller than /equal to ( d )
the permissible values! If the actual calculated value is bigger
than the permissible value the mounted implement is too big for
your tractor.
Important!
x Attach the
minimum ballast to your tractor either in the form
of a mounted implement or a ballast weight!
x If the necessary minimum front ballast (G
V min
) is not
achieved with the front mounted implement (G
V
) in-
crease the weight of the front mounted implement up t
the weight of the minimum ballast (G
V min
)!
x If the necessary minimum rear ballast (G
H min
) is not
achieved with the rear mounted implement (G
H
) in-
crease the weight of the rear mounted implement up to
the minimum ballast (G
H min
)!
x Apply ballast to y
our tractor with a front or rear weight when
the tractor axle load is exceeded on one axle.
To Next Page