Cleaning, maintenance and repairs
ZA-X BAG0235.4
12 Cleaning, maintenance and repairs
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
through
Unintentional falling of the machine raised using the trac-
tor's three-point hydraulic system.
Unintentional falling of raised, unsecured machine parts.
Unintentional start-up and rolling of the tractor-machine
combination.
Secure the tractor and machine against unintentional start-up and
rolling, before carrying out cleaning, maintenance or repair work on
the machine when coupling or decoupling the machine. See also
page 70.
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
through unprotected danger points!
•
Mount protective equipment, which you removed when cleaning,
maintaining and repairing the machine.
• Replace defective protective equipment with new equipment.
12.1 Cleaning
• Pay particular attention to the brake, air and hydraulic hose
lines.
• Never treat brake, air and hydraulic hose lines with benzene,
benzole, petroleum or mineral oils.
• After cleaning, grease the machine, in particular after cleaning
with a high pressure cleaner / steam jet or liposoluble agents.
• Observe the statutory requirement for the handling and removal
of cleaning agents.
Cleaning with a high pressure cleaner / steam jet
• Always observe the following points when using a high pressure
cleaner / steam jet for cleaning:
ο Do not clean any electrical components.
ο Do not clean any chromed components.
ο Never aim the cleaning jet of the cleaning nozzle of the
high pressure cleaner/steam jet directly at lubrication
points, bearings, rating plates, warning signs, and stickers.
ο Always maintain a minimum jet distance of 300mm be-
tween the high pressure cleaning or steam jet cleaning
nozzle and the machine.
ο The set pressure of the high-pressure cleaner/steam jet
must not exceed 120 bar.
ο Comply with safety regulations when working with high
To Next Page
Loading...
