Amazone ZA-X - Coupling the Hydraulic Hose Lines; Uncoupling the Hydraulic Hose Lines

Structure and function
ZA
-X BAG0235.4 01.23
45
5.5.1 Coupling the hydraulic hose lines
WARNING
Risk of crushing, cutting, catching, drawing in and impact from
faulty hydraulic functions when the hydraulic hose lines are in-
correctly connected.
When coupling the hydraulic hose lines, observe the coloured mark-
ings on the hydraulic plugs.
• Check the compatibility of the hydraulic fluids before connecting
the machine to the hydraulic system of the tractor.
Do not mix any mineral oils with biological oils.
• Observe the maximum approved hydraulic fluid pressure of
210 bars.
• Only couple clean hydraulic connectors.
• Plug the hydraulic connector(s) into the hydraulic sleeves, until
the hydraulic connector(s) audibly lock.
• Check the coupling points of the hydraulic hose lines for a cor-
rect, tight seat.
1. Swivel the actuation lever on the tractor control unit on the trac-
tor to float position (neutral position).
2.
Clean the hydraulic connector for the hydraulic hose lines before
connecting them to the tractor.
3. Connect the hydraulic hose line(s) to the tractor control unit(s).
5.5.2 Uncoupling the hydraulic hose lines
1. Swivel the actuation lever on the control
unit on the tractor to float position (neutral
position).
2. Unlock the hydraulic connectors from the
hydraulic sockets.
3. Protect the hydraulic connector and hydrau-
lic socket against soiling using the dust pro-
tection caps.
4. Place the hydraulic hose lines in the hose
cabinet (Fig. 26).
Fig.
26