-X BAG0235.4 01.23
6 Commissioning
This section contains information
• on commissioning your machine.
• on checking how you may connect the machine to your tractor.
• Before operating the machine for the first time the operator must
have read and understood the operating manual.
• Comply with the chapter "Safety information for the user", from
Page 23 when
ο connecting and disconnecting the machine
ο transporting the machine
ο using the machine
• Only couple and transport the machine to/with a tractor which is
suitable for the task.
• The tractor and machine must meet the national road traffic
regulations.
• The operator and the user shall be responsible for compliance
with the statutory road traffic regulations.
WARNING
Risk of contusions, cutting, catching, drawing in and knocks in
the area of hydraulically or electrically actuated components.
Do not block the operator controls on the tractor which are used for
hydraulic and electrical movements of components, e.g. folding,
swivelling and pushing movements. The movement must stop auto-
matically when you release the appropriate control. This does not
apply to equipment movements that:
• are continuous or
• are automatically locked or
• require a floating position or pressed position to function
Check that the spreading discs are installed correctly. Viewed in di-
rection of travel: left spreading disc "L" and right spreading disc "R".
Check that the scales on the spreading discs are installed correctly.
The scales with values from 0 to 20 are assigned to the shorter
spreading vanes and the scales with values from 30 to 50 are as-
signed to the longer spreading vanes.
To Next Page
Loading...
