-X BAG0235.4 01.23
WARNING
Danger from being entangled and drawn in by unguarded PTO
shaft parts in the power transmission area between the tractor
and driven machine!
These risks pose serious injuries or death.
Work only when the drive between the tractor and driven machine is
fully guarded.
• The unguarded parts of the PTO shaft must always be guarded
by a shield on the tractor and a PTO shaft guard on the ma-
chine.
• Check that the shield on the tractor and the PTO shaft guard on
the machine and the safety devices and guards of the extended
PTO shaft overlap by at least 50 mm. If they do not, you must
not power the machine via the PTO shaft.
• Use only the provided PTO shaft or one of the same type.
•
Read and follow the operating manual for the PTO shaft. Correct
use and maintenance of the PTO shaft prevents serious acci-
dents.
• When coupling the PTO shaft, observe the operating manual
from the PTO shaft manufacturer.
• Ensure sufficient clearance in the swivelling range of the PTO
shaft. Insufficient clearance causes damage to the PTO shaft.
• Observe the permitted drive rev. speed of the machine.
• If the PTO shaft has an overload or freewheel clutch, you must
always install the clutch on the machine side.
• Observe the correct installation position of the PTO shaft. The
tractor symbol on the protective tube of the PTO shaft identifies
the tractor-side connection of the PTO shaft.
• Before switching on the universal joint shaft, read and follow the
safety precautions for universal joint shaft operation in the chap-
ter entitled "Safety information for the user", page 27.
To Next Page
Loading...
