Ametek 3050-OLV User Manual

Controller/Interface
AMETEK 3050 Congurator Software
The 3050 Congurator Software provides a graphical user interface to set up
parameters for either a single analyzer or multiple analyzers.
Although you can set and view parameters for multiple analyzers
using the 3050 Congurator Software, you can only work with one
analyzer at any time.
Installing the Congurator Software
1. Insert the Congurator Software CD into the PC’s CD ROM drive.
2. The installation program should begin to run immediately. If it does not start
automatically, click RUN from the Windows Start menu. Type the appropri-
ate drive letter, followed by a colon ( : ) and a backslash ( \ ) and the word
“setup.exe” (for example, d:\setup.exe) and click OK to start the installation
program.
3. Follow the instructions on the subsequent screens to complete the in-
stallation. When you get to the Setup Complete screen, click Finish to
complete the installation. The default location for the 3050 Congurator
Software is in the AMETEK folder.
PN 305200901, Rev YT
Controller/Interface | 3-1

Ametek 3050-OLV Specifications

General

Brand	Ametek
Model	3050-OLV
Category	Measuring Instruments
Language	English