PN 305200901, Rev YT
AMETEK Serial Communication Setup
When you select the AMETEK Serial communication option (Figure 3-2.1), the
following parameter settings are available:
Settings
Port
Select the COM port on your computer where the connection to the
analyzer is installed.
Baud (Rate)
Select the baud rate at which data will be transferred.
RS-232 Port
Select this if the analyzer is connected to an RS-232 port.
RS-485 Port
Select this if the analyzer is connected to an RS-485 port.
Address
Choose the network address to which the analyzer is connected.
3-6 | 3050-OLV Moisture Analyzer
To Next Page
Loading...
Need help?
General
