VNA Commands 5-2 :CALCulate Subsystem
S412E PM PN: 10580-00319 Rev. N 5-11
:CALCulate:LIMit:POINt:DELete
Description: Deletes the active trace active limit point. After deletion, the point that
is immediately to the left of the point that was deleted becomes the
active point. Note that deletion is valid only if 2 or more limit points
exist. Use :CALCulate:LIMit:TYPE to set the currently active limit
line.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To delete the currently active limit point
:CALCulate:LIMit:POINt:DELete
Related Command: :CALCulate:LIMit:POINt:ADD
Front Panel Access: Shift 6 (Limit), Limit Edit, Delete Point
:CALCulate:LIMit:POINt:LEFT
Description: Sets the limit point immediately to the left of the active limit point as
the active point. This makes it active for editing or deleting. Use
:CALCulate:LIMit:TYPE to set the currently active limit line.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To select the point to the left of the active point
:CALCulate:LIMit:POINt:LEFT
Related Command: :CALCulate:LIMit:POINt:RIGHt
Front Panel Access: Shift 6 (Limit), Limit Edit, Next Point Left
:CALCulate:LIMit:POINt:RIGHt
Description: Sets the limit point immediately to the right of the active limit point as
the active point. This makes it active for editing or deleting. Use
:CALCulate:LIMit:TYPE to set the currently active limit line.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To select the point to the right of the active point:
:CALCulate:LIMit:POINt:RIGHt
Related Command: :CALCulate:LIMit:POINt:LEFT
Front Panel Access: Shift 6 (Limit), Limit Edit, Next Point Right
To Next Page
Loading...
