LTE Commands 9-11 [:SENSe] Subsystem
S412E PM PN: 10580-00319 Rev. N 9-21
9-11 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:4TAE:ACTive OFF|ON
[:SENSe]:4TAE:ACTive?
Title: Time Alignment Error (4x4 MIMO configuration)
Description: Sets the state of the TAE measurement for OTA carrier aggregation. In
2x2 MIMO, use the command [:SENSe]:TAE:ACTive.
Parameter: OFF|ON
Parameter Type: <boolean>
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, TAE
[:SENSe]:BANDWidth[:RESolution] 1.4|3|5|10
[:SENSe]:BANDWidth[:RESolution]?
Title:
Bandwidth Resolution
Description:
Sets the channel bandwidth.
Parameter:
1.4|3|5|10
Parameter Type:
<char>
Default Value:
The default bandwidth is 10 MHz.
Front Panel Access:
Setup, BW
[:SENSe]:CC{1|2|3|4|5}:ACTive OFF|ON
[:SENSe]:CC{1|2|3|4|5}:ACTive?
Title:
Active Component Carrier
Description:
Sets the specified Component Carrier (CC) to be on or off.
Parameter:
OFF|ON|0|1
Parameter Type:
<boolean>
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, CC#, CC#
[:SENSe]:CC{1|2|3|4|5}:BANDWidth 1.4|3|5|10
[:SENSe]:CC{1|2|3|4|5}:BANDWidth?
Title:
Component Carrier Bandwidth
Description:
Sets the channel bandwidth of the specified Component Carrier (CC).
Parameter:
1.4|3|5|10
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, CC#, CC#, BW
To Next Page
Loading...
