Anritsu LMR Master S412E - Chapter 12 - NXDN Commands; 12-1:ABORt Subsystem; Chapter 12-NXDN Commands

S412E PM PN: 10580-00319 Rev. N 12-1
Chapter 12 — NXDN Commands
12-1 :ABORt Subsystem
The abort subsystem includes commands that allow the user to stop current measurement
activities on the instrument.
:ABORt
Description: Restarts the current sweep and/or measurement. If
:INITiate:CONTinuous is OFF (i.e., the instrument is in hold mode),
send the command :INITiate[:IMMediate] to trigger the next
sweep. If :INITiate:CONTinuous is ON (i.e., the instrument is in
run mode), a new sweep will start immediately.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To abort a measurement:
:ABORt
Front Panel Access: NA