Anritsu LMR Master S412E - 2-4 SCPI Required Commands; 2-5 SCPI Optional Commands

Programming with SCPI 2-4 SCPI Required Commands
S412E PM PN: 10580-00319 Rev. N 2-3
2-4 SCPI Required Commands
The required SCPI commands that are supported by the S412E are listed in the Table 2-1.
These commands work in all measurement modes and are described in Chapter 3.
2-5 SCPI Optional Commands
Table 2-2 lists the optional SCPI commands that comprise the majority of the command set
that is described in this document. These commands control most of the programmable
functions of the S412E.
The SCPI optional commands are sorted by measurement modes in the following chapters,
and commands may be repeated in more than one mode.
• Chapter 3, “All Mode Commands”
• Chapter 4, “Spectrum Analyzer Commands”
• Chapter 5, “VNA Commands”
• Chapter 6, “Vector Voltmeter Commands”
• Chapter 7, “Fixed WiMAX Commands”
• Chapter 8, “Mobile WiMAX Commands”
• Chapter 10, “P25 Phase 1 Commands”
• Chapter 11, “P25 Phase 2 Commands”
• Chapter 12, “NXDN Commands”
• Chapter 13, “dPMR Commands”
• Chapter 14, “DMR 2 Commands”
• Chapter 15, “PTC Commands”
• Chapter 16, “NBFM Commands”
• Chapter 17, “TETRA Commands”
• Chapter 18, “AM/FM/PM Commands”
Table 2-1. SCPI Required Commands
:STATus
:SYSTem
Table 2-2. SCPI Optional Commands
:ABORt
:CALCulate
:CONFigure
:DISPlay
:FETCh
:FORMat
:INITiate
:INPut
:INSTrument
:MEASure
:MMEMory
:READ
:SENSe
:SOURce
:TRACe
:TRIGger
:UNIT
:[SENSe]