5-11 [:SENSe] Subsystem VNA Commands
5-64 PN: 10580-00319 Rev. N S412E PM
5-11 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not to signal-oriented
parameters.
[:SENSe]:RFON[:STATe] ON|OFF|1|0
Description: Sets the state of the RF output signal at the VNA ports to be either ON
or OFF when the sweep is set to Hold. When set to ON, the RF signal
continues to be energized when the sweep is in hold. When set to OFF,
the RF signal is turned off during the hold condition. Note that the
sweep may require more time to stabilize when it is set to run, if the RF
had been turned OFF during hold.
Cmd Parameter: <boolean> ON|OFF|1|0
Query Response: <bNR1> 1|0
Default Value: ON
Front Panel Access: Shift-3 (Sweep), RF Pwr in Hold
To Next Page
Loading...
