Anritsu LMR Master S412E - Chapter 6 - Vector Voltmeter Commands; 6-1 Introduction; 6-2:FETCh Subsystem; Chapter 6-Vector Voltmeter Commands

S412E PM PN: 10580-00319 Rev. N 6-1
Chapter 6 — Vector Voltmeter
Commands
6-1 Introduction
This chapter describes commands for Vector Voltmeter mode. Only the commands that are
listed in this chapter and in Chapter 3, “All Mode Commands” can be used in Vector
Voltmeter mode. Using commands from other modes may produce unexpected results.
Refer to Chapter 5 for additional information on the following commands.
6-2 :FETCh Subsystem
This subsystem contains commands to fetch the VVM data and relative data.
[:SENSe]:CALibration on page 5-66
[:SENSe]:CORRection on page 5-67
[:SENSe]:CORRection:CKIT on page 5-69
[:SENSe]:CORRection:CKIT:USER on page 5-70
[:SENSe]:CORRection:COLLect on page 5-71