15-8 :MMEMory Subsystem PTC Commands
15-16 PN: 10580-00319 Rev. N S412E PM
15-8 :MMEMory Subsystem
The Mass Memory subsystem contains functions that provide access to the instrument’s
setup and data storage.
:MMEMory:LOAD:STATe <integer>,<filename>
Description: Recalls a previously stored instrument setup in the current save
location.
The setup file to be loaded is specified by <filename>. <filename>
should be enclosed in either single quotes (‘ ’) or double quotes (“ ”) and
should contain a file extension “.stp”. Use the command MMEMory:MSIS
to set the current save location. The <integer> parameter is not
currently used, but it must be sent. Send a 1.
Cmd Parameters: <integer>,<filename>
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To recall a setup file:
:MMEMory:LOAD:STATe 1,"xxx.stp"
Front Panel Access: Shift 7 (File), Recall
To Next Page
Loading...
