4-2 :CALCulate Subsystem Spectrum Analyzer Commands
4-2 PN: 10580-00319 Rev. N S412E PM
4-2 :CALCulate Subsystem
The commands in this subsystem process data that has been collected via the SENSe
subsystem.
:CALCulate:LIMit:ALARm OFF|ON|0|1
:CALCulate:LIMit:ALARm?
Title: Limit Alarm
Description: Enables/disables the currently active limit line alarm. Setting the value
to ON or 1 will turn on the limit alarm. Setting the value to OFF or 0
will turn off the limit alarm. The query version of the command returns
a 1 if the currently selected limit line alarm is set to ON and returns 0 if
OFF. Use :CALCulate:LIMit:TYPe to set the currently active limit line.
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Default Value: OFF
Example: To turn off limit alarm:
:CALCulate:LIMit:ALARm OFF
:CALCulate:LIMit:ALARm 0
To turn on limit alarm:
:CALCulate:LIMit:ALARm ON
:CALCulate:LIMit:ALARm 1
Related Command: :CALCulate:LIMit:TYPe
Front Panel Access: Shift-6 (Limit), Limit Alarm
:CALCulate:LIMit:CENTer
Title: Move Limit to Current Center Frequency
Description: Moves the center of the current active limit line to the center frequency.
Example: To move the limit to the current center:
:CALCulate:LIMit:CENTer
Front Panel Access: Shift-6 (Limit), Limit Move, Move Limit to Current Center Freq
:CALCulate:LIMit:ENVelope:CREate
Title: Create Limit Envelope
Description: Creates a limit envelope. This generates a limit line that formed a mask
just above or below the existing signals. Note that this command will
turn on the currently selected limit line if it is not already on. Use
:CALCulate:LIMit:TYPe to set the currently active limit line.
Example: To create a limit envelope:
:CALCulate:LIMit:ENVelope:CREate
Front Panel Access: Shift-6 (Limit), Limit Envelope, Create Envelope
To Next Page
Loading...
