5-2 :CALCulate Subsystem VNA Commands
5-4 PN: 10580-00319 Rev. N S412E PM
:CALCulate:LIMit Subsystem
This subsystem defines the limit lines and controls the limit check.
:CALCulate:LIMit:ALARm OFF|ON|0|1
:CALCulate:LIMit:ALARm?
Description: Enables/disables the active trace currently selected limit line alarm.
Setting the value to ON or 1 turns on the active trace limit alarm.
Setting the value to OFF or 0 turns off the active trace limit alarm.
The query version of the command returns a 1 if the active trace
currently selected limit line alarm is set to ON and returns 0 if set to
OFF. Use :CALCulate:LIMit:TYPE to set the currently active limit
line.
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: OFF or 0 (query returns 0 for OFF)
Example: To turn off limit alarm
:CALCulate:LIMit:ALARm OFF
:CALCulate:LIMit:ALARm 0
To turn on limit alarm
:CALCulate:LIMit:ALARm ON
:CALC:LIM:ALAR 1
Related Command: :CALCulate:LIMit:TYPE
Front Panel Access: Shift 6 (Limit), Limit Alarm
:CALCulate<Tr>:LIMit:LOWer:POINt?
Description: Returns the number of points currently in the lower limit line of the
given trace <Tr>. <Tr> is the trace number in the range 1 to 4. If no
trace number is specified, then the <Tr> parameter defaults to trace
number 1.
Cmd Parameter: NA (query Only)
Query Response: <NR1> <integer>
Example: To query for the lower limit total point on trace #2:
:CALC2:LIM:LOW:POIN?
Front Panel Access: NA
To Next Page
Loading...
