VNA Commands 5-2 :CALCulate Subsystem
S412E PM PN: 10580-00319 Rev. N 5-5
:CALCulate<Tr>:LIMit:LOWer:POINt:ADD
Description: Adds a new limit point to the lower limit line of the given trace <Tr>.
<Tr> is the trace number in the range 1 to 4. If no trace number is
specified, then the <Tr> parameter defaults to trace number 1.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To add a point to the lower limit line on trace 2:
:CALC2:LIM:LOW:POIN:ADD
Front Panel Access: Shift 6 (Limit), Limit Edit, Add Point
:CALCulate<Tr>:LIMit:LOWer:POINt:DELete
Description: Deletes the lower limit point of the given trace <Tr>. After deletion,
the point that is immediately to the left of the point that was deleted
becomes the active point. <Tr> is the trace number in the range 1 to 4.
If no trace number is specified, then the <Tr> parameter defaults to
trace number 1. Note that deletion is valid only if more than 2 limit
points are present.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To delete the trace 4 lower limit current active point:
:CALCulate4:LIMit:LOWer:POINt:DELete
Front Panel Access: Shift 6 (Limit), Limit Edit, Delete Point
:CALCulate<Tr>:LIMit:LOWer:POINt:LEFT
Description: Sets the limit point to the left of the lower limit active point of the given
trace <Tr> as the new active point. <Tr> is the trace number in the
range 1 to 4. If no trace number is specified, then the <Tr> parameter
defaults to trace number 1.
Cmd Parameter: NA
Query Response: NA (no query)
Example: To make the lower limit point to the left of the current active point of
trace 2 as the new active point:
:CALCulate2:LIMit:LOWer:POINt:LEFT
Front Panel Access: Shift 6 (Limit), Limit Edit, Next Point Left
To Next Page
Loading...
