17-13 [:SENSe] Subsystem TETRA Commands
17-32 PN: 10580-00319 Rev. N S412E PM
17-13 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:APPLication:TST?
Description: Triggers an application self-test. This command returns a 1 if all the
tests passed and a 0 if one or more of the tests failed. Use
[:SENSe]:APPLication:TST:RESult? to retrieve the detailed
results of the test.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To trigger a self-test:
:SENSe:APPLication:TST?
Front Panel Access: Shift 8 (System), Application Self Test
Note
The application self-test can take longer than five seconds to complete, depending
on the current application. Add a delay of at least 10 seconds to allow the
application self-test to complete to avoid any time-out errors.
To Next Page
Loading...
