Anritsu LMR Master S412E - Chapter 3 - All Mode Commands; 3-1 Introduction; 3-2:FETCh GPS Subsystem; Chapter 3-All Mode Commands

All Mode Commands 3-1 Introduction
S412E PM PN: 10580-00319 Rev. N 3-1
Chapter 3 — All Mode Commands
3-1 Introduction
The commands that are listed in this chapter are functional in all modes of operation.
3-2 :FETCh GPS Subsystem
Use this command to get GPS information.
:FETCh:GPS?
Title: Fetch GPS Information
Description: Returns the GPS fix status, UTC timing information, and the GPS
location. The results are returned as a set of comma-delimited values in
the following format:
<fix status>, <date/time>, <latitude>, <longitude>
The <fix status> field is either “GOOD FIX” or “NO FIX”,
depending whether the GPS receiver is currently calculating position
data. If “NO FIX” is the value of the <fix status> field, then no
data follows.
The date and time (<date/time> field) are returned in the following
format:
Www Mmm dd hh:mm:ss yyyy
Where Www is the weekday in letters, Mmm is the month in letters, dd
is the day of the month, hh:mm:ss is the time (24-hour time), and
yyyy is the year.
Both <latitude> and <longitude> fields are expressed in radians.
A negative latitude value corresponds to a “south” reading. A negative
longitude value corresponds to a “west” reading.
Related Command: :SENSe:GPS
Front Panel
Access: Shift-8 (System), GPS, GPS Info