VNA Commands 5-2 :CALCulate Subsystem
S412E PM PN: 10580-00319 Rev. N 5-33
:CALCulate:TRANsform:DISTance:UNIT METers|FEET
:CALCulate:TRANsform:DISTance:UNIT?
Description: Sets the units to be used for DTF measurements. The query version of
this command returns the string “METER” if the current distance unit
is set to meter, and otherwise returns the string “FEET”.
Syntax: :CALCulate:TRANsform:DISTance:UNIT METers|FEET
:CALCulate:TRANsform:DISTance:UNIT?
Cmd Parameter: <char> METers|FEET
Query Response: <char> METER|FEET
Default Value: METers when setting, METER for query
Example: To set the distance unit to Meter:
:CALCulate:TRANsform:DISTance:UNIT METers
:CALC:TRAN:DIST:UNIT MET
To set the distance unit to Feet:
:CALC:TRAN:DIST:UNIT FEET
:CALCulate:TRANsform:DISTance:UNIT FEET
Front Panel Access: Shift 8 (System), Application Options, Units
:CALCulate<Tr>:TRANsform:DISTance:DATA?
Description: Produces the distance list in meters for the given trace. <Tr> is the
trace number in the range 1 to 8 (1 to 4 for Traces TR1 to TR4 and
5 to 8 for Memory M1 to M4). If no trace number is specified, then the
<Tr> parameter defaults to trace number 1. The response begins with
an ASCII header that specifies the number of data bytes. It appears in
the format #AX, where A is the number of digits in X, and X is the
number of bytes that follow the header. Each distance value is returned
in scientific notation and separated by a comma delimiter.
Cmd Parameter: NA (query only)
Query Response: <char> returns block data (meters)
Default Unit: Meters
Front Panel Access: NA
To Next Page
Loading...
