Anritsu LMR Master S412E - Page 176

5-11 [:SENSe] Subsystem VNA Commands
5-68 PN: 10580-00319 Rev. N S412E PM
[:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude]:SMCHart
50|75
[:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude]:SMCHart?
Description: Sets the Smith Chart reference impedance. Sets 50 for 50 ohm. Sets
75 for 75 ohm. The query form of the command returns the current
Smith Chart reference impedance in ohms.
Cmd Parameter: <char> 50|75
Query Response: <char> 50|75
Default Value: 50
Range: 50, 75
Front Panel Access: Scale, Reference Impedance
[:SENSe]:CORRection[:STATe] OFF|ON
[:SENSe]:CORRection[:STATe]?
Description: Turns the calibration error correction ON or OFF. Note that error
correction can be turned ON only if valid calibration is available.
Parameter: OFF|ON
Cmd Parameter: <boolean> OFF|ON|0|1
Query Response: <bNR1> 0|1
Default Value: 0
Front Panel Access: Shift-2 (Calibrate), Cal Correction