Anritsu LMR Master S412E - 8-9:READ Subsystem

Mobile WiMAX Commands 8-9 :READ Subsystem
S412E PM PN: 10580-00319 Rev. N 8-19
8-9 :READ Subsystem
This set of commands combines the ABORt, INITiate and FETCh commands. It aborts any
current triggering sequence and sets the trigger state to idle. It then initiates a new active
measurement (i.e., begins the collection of new data). When the measurement is complete, it
returns the result. These commands will not switch to another measurement.
To get the current measurement data, use the FETCh command.
:READ:DEMod:CONStln?
Title: Read Constellation
Description: Triggers a new Constellation measurement and returns the results:
EVM (rms), EVM (pk), RCE (rms), RCE (pk), Carrier Frequency, Freq
Error, Freq Error, and the Base Station ID. The Constellation
measurement must be the active measurement (specified by
:CONFigure:DEMod CONStln). The current measurement can be
queried using the command :CONFigure?
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
Related Command: :FETCh:DEMod:CONStln?
:CONFigure:DEMod CONStln
:READ:DEMod:EVSCarrier?
Title: Read EVM vs. Sub Carrier
Description: Triggers a new EVM vs. Sub Carrier measurement and returns the
results: EVM (rms), EVM (pk), RCE (rms), RCE (pk), Carrier
Frequency, Freq Error, Freq Error, and the Base Station ID. The EVM
vs. Sub Carrier measurement must be the active measurement
(specified by :CONFigure:DEMod EVSCarrier). The current
measurement can be queried using the command :CONFigure?
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
Related Command: :FETCh:DEMod:EVSCarrier?
:CONFigure:DEMod EVSCarrier
:READ:DEMod:EVSYmbol?
Title: Read EVM vs. Symbol
Description: Triggers a new EVM vs. Symbol measurement and returns the results:
EVM (rms), EVM (pk), RCE (rms), RCE (pk), Carrier Frequency, Freq
Error, Freq Error, and the Base Station ID The EVM vs. Symbol
measurement must be the active measurement (specified by
:CONFigure:DEMod EVSYmbol). The current measurement can be
queried using the command :CONFigure?