11-13 [:SENSe] Subsystem P25 Phase 2 Commands
11-44 PN: 10580-00319 Rev. N S412E PM
[:SENSe]:FREQuency:SPAN 25|50|100|500|1000|5000
[:SENSe]:FREQuency:SPAN?
Description: Sets the span of the Spectrum display in P25p2 Analyzer measurement
mode.
Note: Span value is set and returned in kHz.
Cmd Parameters: 25|50|100|500|1000|5000
Query Parameters: NA
Range: 25|50|100|500|1000|5000
Default Value: 25
Default Unit: kHz
Example: To set the span to 1 MHz:
:SENSe:FREQuency:SPAN 1000
Front Panel Access: Frequency, Span
[:SENSe]:POWer[:RF]:RANGe[:IMMediate]
Description: Turns off auto ranging and adjusts the receiver reference level once.
In P25p2 Analyzer measurement, this command adjusts the receiver
reference level of the spectrum graph.
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To adjust range:
:POWer:RANGe
Front Panel Access: Amplitude, Adjust Rx Range
To Next Page
Loading...
