NXDN Commands 12-13 [:SENSe] Subsystem
S412E PM PN: 10580-00319 Rev. N 12-37
[:SENSe]:DM:BWIDth 12.5|6.25
[:SENSe]:DM:BWIDth?
Description: Sets the modulation bandwidth. Please note that setting the modulation
bandwidth will restart the sweep.
Note: Modulation bandwidth value is set and returned in kHz.
Cmd Parameters: 12.5|6.25
Query Parameters: NA
Range: 12.5|6.25
Default Value: 12.5
Default Unit: kHz
Example: To set the modulation bandwidth to 6.25 kHz:
:DM:BWIDth 6.25
Front Panel Access: Setup, Mod Bandwidth
[:SENSe]:DM:PATTern 1031hz|O.153|VOICe|CTRLchan
[:SENSe]:DM:PATTern?
Description: Sets the receiver pattern type. Please note that setting the Rx pattern
type will restart the sweep.
Cmd Parameters: 1031hz|O.153|VOICe|CTRLchan
Query Parameters: NA
Range: 1031hz|O.153|VOICe|CTRLchan
Default Value: 1031hz
Default Unit: NA
Example: To set the modulation pattern to voice:
:DM:PATTern VOICe
Front Panel Access: Setup, Rx Pattern
To Next Page
