TETRA Commands 17-11 :TRACe Subsystem
S412E PM PN: 10580-00319 Rev. N 17-27
BER_MAPPING_EXCELLENT
Threshold at which the BER mapping value is deemed
excellent (Only used in P25, P25p2, NXDN, dPMR,
DMR2, PTC, TETRA).
BER_MAPPING_VERY_GOOD
Threshold at which the BER mapping value is deemed
very good (Only used in P25, P25p2, NXDN, dPMR,
DMR2, PTC, TETRA).
BER_MAPPING_GOOD
Threshold at which the BER mapping value is deemed
good (Only used in P25, P25p2, NXDN, dPMR,
DMR2, PTC, TETRA).
BER_MAPPING_FAIR
Threshold at which the BER mapping value is deemed
fair (Only used in P25, P25p2, NXDN, dPMR, DMR2,
PTC, TETRA).
BER_MAPPING_POOR
Threshold at which the BER mapping value is deemed
poor (Only used in P25, P25p2, NXDN, dPMR, DMR2,
PTC, TETRA).
MOD_FID_MAPPING_EXCELLENT
Threshold at which the Mod Fid mapping value is
deemed excellent (Only used in P25, P25p2, NXDN,
dPMR, DMR2, PTC).
MOD_FID_MAPPING_VERY_GOOD
Threshold at which the Mod Fid mapping value is
deemed very good (Only used in P25, P25p2, NXDN,
dPMR, DMR2, PTC).
MOD_FID_MAPPING_GOOD
Threshold at which the Mod Fid mapping value is
deemed good (Only used in P25, P25p2, NXDN,
dPMR, DMR2, PTC).
MOD_FID_MAPPING_FAIR
Threshold at which the Mod Fid mapping value is
deemed fair (Only used in P25, P25p2, NXDN, dPMR,
DMR2, PTC).
MOD_FID_MAPPING_POOR
Threshold at which the Mod Fid mapping value is
deemed poor (Only used in P25, P25p2, NXDN,
dPMR, DMR2, PTC).
EVM_MAPPING_EXCELLENT
Threshold at which the EVM mapping value is
deemed excellent (Only used in TETRA).
EVM_MAPPING_VERY_GOOD
Threshold at which the EVM mapping value is
deemed very good (Only used in TETRA).
EVM_MAPPING_GOOD
Threshold at which the EVM mapping value is
deemed good (Only used in TETRA).
EVM_MAPPING_FAIR
Threshold at which the EVM mapping value is
deemed fair (Only used in TETRA).
EVM_MAPPING_POOR
Threshold at which the EVM mapping value is
deemed poor (Only used in TETRA).
MAPPING_TYPE
Mapping value that is being compared with threshold
values.
Table 17-1. Returned Parameter Values in Trace Preamble (Sheet 5 of 7)
Parameter Name Description
To Next Page
Loading...
