4-8 :MEASure Subsystem Spectrum Analyzer Commands
4-30 PN: 10580-00319 Rev. N S412E PM
:MEASure:CHPower:CHPower?
Title: Measure Channel Power
Description: Sets the active measurement to channel power, sets the default
measurement parameters, triggers a new measurement and returns the
channel power result. To measure both channel power and channel
power density use :MEASure:CHPower? It is a combination of the
commands :CONFigure:CHPower and :READ:CHPower:CHPower? For
a description of the default channel power measurement parameters,
see :CONFigure:CHPower. To make a channel power measurement
with settings other than the default values, send:
:CONFigure:CHPower
Commands to set desired settings
:READ:CHPower:CHPower?
Default Unit: Current amplitude units
Related Command: :MEASure:CHPower?
:MEASure:CHPower:DENSity?
:CONFigure:CHPower
:MEASure:CHPower:DENSity?
Title: Measure Channel Power Density
Description: Sets the active measurement to channel power, sets the default
measurement parameters, triggers a new measurement and returns the
channel power density result. To measure both channel power and
channel power density use :MEASure:CHPower? It is a combination of
the commands :CONFigure:CHPower and :READ:CHPower:DENSity?
For a description of the default channel power measurement
parameters, see :CONFigure:CHPower. To make a channel power
measurement with settings other than the default values, send:
:CONFigure:CHPower
Commands to set desired settings
:READ:CHPower:DENSity?
Default Unit: Current amplitude units
Related Command: :MEASure:CHPower?
:MEASure:CHPower:CHPower?
:CONFigure:CHPower
To Next Page
Loading...
