4-12 :TRIGger Subsystem Spectrum Analyzer Commands
4-50 PN: 10580-00319 Rev. N S412E PM
:TRIGger[:SEQuence]:VIDeo:DELay <percentage> or <time>
:TRIGger[:SEQuence]:VIDeo:DELay?
Title: Video Trigger Position (Time)
Description: This command sets the video triggering delay as either a percentage of
the display or in time units. If setting the delay by time is desired, then
time units must be specified when sending the command. The query
version of this command returns the video triggering delay as a
percentage.
Parameter: <percentage> or <time>
Default Value: –1
Default Unit: %
Range: –100% to +200% (–1 ms to +2 ms)
Example: To set the delay to 1 ms:
:TRIGger:SEQuence:VIDeo:DELay 1 ms
To set the delay to 1%:
:TRIGger:SEQuence:VIDeo:DELay 1
Front Panel Access: Shift-3 (Sweep), Triggering, Delay
To Next Page
Loading...
