5-13
2) BSTMD burst mode
Sets whether to measure carrier frequency, burst width, or burst period during burst measurement.
Command : BSTMD n
Query : BSTMD?
Response : BSTMD n
<Program data>
Value of n Value set
0 .......................... CARRIER FREQUENCY (initial value)
1 .......................... BURST WIDTH
2 .......................... BURST PERIOD
Table 5-4 Relationship Measurements According to Burst Measurement Polarity
Burst Measurement Polarity
Measurement at Burst Off time
Measurement of Off-Off period
Measurement at Burst On time
Measurement of On-On period
Burst Width
Burst Period
Positive Negative
Measurement
3) BSTPL burst polarity
Specifies the position (see BSTMD message) as follows when measuring pulse width and burst period.
Command : BSTPL n
Query : BSTPL?
Response : BSTPL n
<Program data>
Value of n Value set
0 .......................... POSITIVE (initial value)
1 .......................... NEGATIVE
5.4 Device Message List
To Next Page
Loading...