Section 5 GPIB
5-14
4) BSTWDT burst width
Specifies burst width to measure.
Command : BSTWDT n
Query : BSTWDT?
Response : BSTWDT n
<Program data>
Value of n Value set
0 .......................... Wide (initial value : burst width of 1 us to 0.1 s)
1 .......................... Narrow (burst width of 100 ns to 0.1 s)
Note that Wide requires a carrier frequency of 600 MHz and Narrow requires 1 GHz.
(3) C
1) CNTMD count mode
Sets whether the Input1 count method will be high speed (reciprocal) or normal (direct count).
Command : CNTMD n
Query : CNTMD?
Response : CNTMD n
<Program data>
Value of n Value set
0 .......................... FAST (initial value)
1 .......................... NORMAL
(4) D
1) DSTA data storage start
Starts the data storage function which is used to trace the frequency measurement values in the internal memory.
Command : DSTA
2) DSTP data storage stop
Stops the data storage function that is used to trace the frequency measurement values in the internal memory.
Command : DSTP
To Next Page
Loading...