5-15
(5) E
1) ESE2 End Event Status Enable Register
Sets (0 to 255) each bit of the End Event Status Enable Register which is one of the GPIB status enable registers.
Command : ESE2 n
Query : ESE2?
Response : ESE2 n
<Program data>
Value of n Value set
0 to 255 ............... See 5.4.3 “Status Register.”
2) ESE3 ERR Event Status Enable Register
Sets (0 to 255) each bit of the ERR Event Status Enable Register which is one of the GPIB status enable registers.
Command : ESE3 n
Query : ESE3?
Response : ESE3 n
<Program data>
Value of n Value set
0 to 255 ............... See 5.4.3 “Status Register.”
3) ESR2 END Event Status Register
Returns the value of the END Event Status Register which is one of the GPIB status registers.
Query : ESR2?
Response : n
<Response Data>
See 5.4.3 “Status Register.”
4) ESR3 ERR Event Status Enable Register
Returns the value of the ERR Event Status Register which is one of the GPIB status registers.
Query : ESR3?
Response : n
<Response Data>
See 5.4.3 “Status Register.”
5.4 Device Message List
To Next Page
Loading...